surf science
-
He is at it again, the surf scientist Roger Hall with one of his latest
creations, more to reveal soon, Mike C.
September 22, 2008
Get the Fin Box In.
I made this template using some left over pegboard and raising it up a tad using some left over balsa. The cut went well. No problems cutting the hole. I used a 1/4 inch router bit with the DeWalt router. Had to make the template pretty low because the bit I used wasn't long enough to cut out a 1 1/8 inch hole.
I needed to do shallow cuts. Probably a 1/4 of an inch at a time. It was weird, any deeper than that, the sound it made was intolerable although it cut just fine.
Labels:
Building a Surfboard
,
Displacement Hull
,
First Board
No comments :
Post a Comment
Discuss it Here at the BoardSide Forum